High Automatization Plastic Bottle Packaging Machine 6000 BPH -
automatic PET bottle blow molding machine
1. 1-6 cavity
4. High quality components
SPC Linear Pet Blow Molding Machine, 3-16 cavities, 2000-16000
bottle/hr, Volumeter 25-2000mL Pet bottle.
A. Brief Introduction
SPC-L series are fully-automatic pet stretch-blow molding
machines(preheat). It has 3 to 16 cavities and the maximum capacity
of the products is 2000mL. It can blow bottles in shapes:
carbonated, mineral, pesticide, cosmetics, wide-mouth, hot filling,
and other packing containers, which is made of plastic of
crystalline type, such as PET and PP etc.
1). High Automatization
2). High Intelligence:The machine can be controlled through touch
screen and running status is shown on it.
3). High Quanlity:Steady infrared heating system blowing and highly
precise blow-mould closing system ensure quality.
4). High Speed:6000BPH(6-cavity), 8000BPH(8-cavity),
5). No Contamination:Closed production zone, good self-lubrication
system avoid contamination.
6). Low Cost:Low consumption of electricity, air and water.
7). High Transparency:Easy maintenance, absolute safely, visual
inspection, low noise.
a). PLC colour display: SIEMENS(GERMANY)
b). Pneumatic parts:FESTO(GERMANY)
c). Controller of preform transfer:Servo motor National(JAPAN)
d). Other electric parts are all world-famous brand
C. 1. Stable performance with advanced PLC.
C. 2. Conveying preforms automatically with conveyor.
C. 3. Strong penetrability and good and swift distribution of the
heat by letting the bottles rotate by itself and revolute in the
rails simultaneously in the infrared preheater.
C. 4. High adjustability to enable the preheater to preheat
preforms in shapes by adjusting the light tube and the length of
the reflecting board in the preheating area, and eternal
temperature in the preheater with an automatic thermostatic
C. 5. High safeties with security automatic-locking apparatus in
each mechanical action, which will make the procedures turn into a
state of safety in case of a breakdown in certain procedure.
C. 6. No contamination and low noise with the air cylinder to drive
the action instead of the oil pump.
C. 7. Satisfaction with different atmospheric pressure for blowing
and mechanical action by dividing the blowing and action into three
parts in the air pressure diagram of the machine.
C. 8. Strong clamping force with high pressure and double crank
links to lock the mold.
C. 9. Two ways of operating: automatic and manual.
C. 10. Safe, reliable, and unique design of the position of valve
to make the air pressure diagram of the machine easier to
C. 11. Low cost, high efficiency, easy operation, easy maintenance,
etc, with automatic technological process.
C. 12. Contamination is avoided for the bottle body.
C. 13. Ideal effect of the chilling with the chilling system.
C. 14. Easy installation and starting
C. 15. Low rejection rate: less than 0.2 percent.
D. Technical Parameter:
Number of cavity
Number of lamp
Actual power consumption
Operatating low pressure
Low pressure consuming
High pressure consuming